Replacement Tub Center Part for MOST White Mountain Ice Cream Makers Freezers

Description

This piece is one of the first to go bad on these White Mountain ice cream makers. The original piece is make of cast iron and over time, the salt water destroys it.
This replacement part is 3D printed. The dimensions were made to exactly match the original part. I measured a good part with a caliper down to the thousandth of an inch. This measures approximately 2.86 inches long and 1.21 inches at the widest point. It is 0.89 inches in height.
The last two photos are of an original cast iron piece that these were made to replicate.
This part was put into use to test functionality. It works as it is intended.
This will come with the correct size screws to secure it into you wood bucket. Make sure not to over tighten the screws as I could see the part eventually breaking if you put it under too much pressure.
If you have any questions, send me a message.
Check my feedback and buy with confidence.
Check the reviews on this specific item.  I haven't had any complaints.